skipd1
Cast Iron
- Joined
- Jan 6, 2010
- Location
- Bismarck, ND
I'm at a quandary as to how to remove these flanges from this motor shaft. I think they are pressed on but not sure. The shaft diameter on the inside of the shaft is 0.67" and the outside is 0.625 so it appears the flanges would pull off over the threads. I don't want to damage this shaft or the flanges. My original plan would be to use a bearing puller and maybe apply some heat to the flange and hope for the best. I'm hoping someone with experience in this area can give me some advise.