brokenrinker
Plastic
- Joined
- Jul 6, 2012
- Location
- St. Louis
Is the thread depth (in this case .5 inch) measured from the top surface of the part or the bottom of the countersink?
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
How would you interpret this?
- Thread starter brokenrinker
- Start date
- Replies 4
- Views 948
Is the thread depth (in this case .5 inch) measured from the top surface of the part or the bottom of the countersink?
AARONT
Stainless
- Joined
- Feb 19, 2013
- Location
- Madison, WI
Top of the feature. Same place you're measuring the hole depth from.
I can't get the pix to blow up enough to read it clearly.
Much like the title of this thread....
In before the lock.
brokenrinker
Plastic
- Joined
- Jul 6, 2012
- Location
- St. Louis
I can't get the pix to blow up enough to read it clearly.
Much like the title of this thread....
In before the lock.
Sorry about that. Better?
Trueturning
Diamond
- Joined
- Jul 2, 2019
Usually it is top of the part. That surface remains pretty set. Everything is referenced from the top of the part.
