Hi all,
First post for me, so Hi again!
I'm running out of ideas for a fixture/workholding of a part.
In this part I need to mill three 'bayonet lockings'(?), 120 degrees apart (at the circumference).
The part dimensions are Ø170mm (6.7") by 85mm (3,4"), I added a picture also.
Now the question is what do you think is the best fixture for this part, I need to make 50 of them.
Hope to hear from you,
Coert
First post for me, so Hi again!
I'm running out of ideas for a fixture/workholding of a part.
In this part I need to mill three 'bayonet lockings'(?), 120 degrees apart (at the circumference).
The part dimensions are Ø170mm (6.7") by 85mm (3,4"), I added a picture also.
Now the question is what do you think is the best fixture for this part, I need to make 50 of them.
Hope to hear from you,
Coert