Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
5If I thread the whole portion of the shafts, and completely screw them down into the holes, will the wall/face of the shaft against the block align the shafts straight?
Like this: RHJU-4467-432FGYTF-5432 — ImgBB
Then (if possible) tap the rod and use a bolt from the outside end, so you don't have to try to turn the rod in a snug hole to tighten ....A counter bore that is bored to fit the OD of your pins would be better...
Notice
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.