Hi ALL, to start with, I hope your all doing as well as you possibly can in the current situation and I wish you all the best
I have this valve here:
One side has a thread of 1/4" sae, this is the side I need to work with, what I need to do is drill and tap a plastic block, screw this in and try make a tight seal, as I have no access to the other side / inside of the block, any tips on the best way to do this to get a good tapered seat for this to seal on. also what size/type drill bit and tap would need
I also have a pressure gauge that I might need to use with this, the gauge has 1/4 bspp thread with a small aluminum sealing washer, again need advise on drilling and tapping, as this has flat seal do flat drill bits exist for doing this kind of work
Thanks
I have this valve here:
One side has a thread of 1/4" sae, this is the side I need to work with, what I need to do is drill and tap a plastic block, screw this in and try make a tight seal, as I have no access to the other side / inside of the block, any tips on the best way to do this to get a good tapered seat for this to seal on. also what size/type drill bit and tap would need
I also have a pressure gauge that I might need to use with this, the gauge has 1/4 bspp thread with a small aluminum sealing washer, again need advise on drilling and tapping, as this has flat seal do flat drill bits exist for doing this kind of work
Thanks