Have a Matsuura 510v with yasnac MX3 1986
We purchased this a couple weeks ago. Was getting it going. Had everything working all axis ,spindle, ect. ran a program went to do tool change and had alarms. we worked through that while all axis were at home position. Now we have no alarms but have no movement of any axis or spindle. acts like it is in emergency stop but no alarms. All servos are on and ready with no errors. I am guessing it is something simple since it was working fine.
Not sure where to look.
Any ideas?
Thanks Jarrod
We purchased this a couple weeks ago. Was getting it going. Had everything working all axis ,spindle, ect. ran a program went to do tool change and had alarms. we worked through that while all axis were at home position. Now we have no alarms but have no movement of any axis or spindle. acts like it is in emergency stop but no alarms. All servos are on and ready with no errors. I am guessing it is something simple since it was working fine.
Not sure where to look.
Any ideas?
Thanks Jarrod
Last edited: