Lumberjack
Hot Rolled
- Joined
- Jun 3, 2006
- Location
- Sweden
Dear all,
I´m looking for info for an older manual Mazak 18"x60 lathe, even a complete manual...
No.1 right now is I´m wondering what is the taper in the spindle normally? The bore is 80mm / 3 1/8"? It has D1-8. I´d take a wild guess at Metric 80 cone??
As you may have figured out it´s not in my possesion, yet.
Not sure to post it here or in the General section but I know for a fact the are many lathe specialist in here. And if things go well I´ll be happy to share it with you in the future, then it will fit very nicely under this Machine reconditioning section...
Here is a link to a similar lathe on ebay, in a Very different condition than the one I´m eyeing...
MAZAK MK 46 X 15 Gap Cama Motor Torno de 18/25" "X 6" CC 3.14 Eje de diametro DRO | eBay
I´m looking for info for an older manual Mazak 18"x60 lathe, even a complete manual...
No.1 right now is I´m wondering what is the taper in the spindle normally? The bore is 80mm / 3 1/8"? It has D1-8. I´d take a wild guess at Metric 80 cone??
As you may have figured out it´s not in my possesion, yet.
Not sure to post it here or in the General section but I know for a fact the are many lathe specialist in here. And if things go well I´ll be happy to share it with you in the future, then it will fit very nicely under this Machine reconditioning section...
Here is a link to a similar lathe on ebay, in a Very different condition than the one I´m eyeing...
MAZAK MK 46 X 15 Gap Cama Motor Torno de 18/25" "X 6" CC 3.14 Eje de diametro DRO | eBay