more hossfeld bender questions

metalmagpie · Jul 26, 2018

I've been thinking about making some tooling for my Hossfeld. Can anyone provide some dimensions for the 63B E-type clamp? They're pretty spendy from Hossfeld, so I think they'd be a good choice to make.

Also wondering how wide the 20B2 flat face dies are. I realize this likely varies with radius somewhat but I'm guessing they're all in the 7-9" range. Don't want to make them and then have them be too narrow.

Thanks!

metalmagpie

Rob F. · Jul 26, 2018

I made a set of the 63b edgebend blocks for mine. I think it was 2 1/4 square bar with a 1/2" slot, maybe 1 1/2 deep and a 3/4 hole for the pin behind the slot. If I remember right it is a little longer than tall, not a cube. I think the hossfeld ones have set screws that push on a floating plate in the slot to adjust thickness of bent bar. I did not do that but probably will.

metalmagpie · May 22, 2020

Wondering if anyone else has the dimensions I need? Recall that the two blocks are different as one goes on the main frame and one the swinging frame.

metalmagpie

Search

Largest Manufacturing Technology Community on the Web

Search

more hossfeld bender questions

metalmagpie

Titanium

Rob F.

Diamond

metalmagpie

Titanium

Similar threads