Boat Brat
Aluminum
- Joined
- May 11, 2013
- Location
- Germany, New Zealand.
Hi All,
I’m trying to figure out a nice clean/simple way to store my 40 position tool holders. I see lots of good ideas that fit the dovetail style holders but very little for the 40 position ones. They seem a bit of a pain to make a simple post to secure them on on a rack.
The 2 options I have at the moment are.
2 pins to slide in to the holes on the outside edge, this I think will be a bit fussy to put the holder on.
The other is just a simple rectangular cutout to fit around the base of the whole holder below the tool, simple but will be prone to getting chips stuck in it and not the most secure holder as it will only be about a 1/4 inch deep pocket.
Anyone got a better idea?
Picture of a 40 position For those who are not familiar.
Thanks.
I’m trying to figure out a nice clean/simple way to store my 40 position tool holders. I see lots of good ideas that fit the dovetail style holders but very little for the 40 position ones. They seem a bit of a pain to make a simple post to secure them on on a rack.
The 2 options I have at the moment are.
2 pins to slide in to the holes on the outside edge, this I think will be a bit fussy to put the holder on.
The other is just a simple rectangular cutout to fit around the base of the whole holder below the tool, simple but will be prone to getting chips stuck in it and not the most secure holder as it will only be about a 1/4 inch deep pocket.
Anyone got a better idea?
Picture of a 40 position For those who are not familiar.
Thanks.