Hello im trying to get a G84 tapping cycle to work and I have no clue how to get it to go. it will go to position and just stay in the same spot. The only clue I have from a past job when my father was alive is (param 5200 bit0=1) written on a print from the previous time this job was ran.
I go to system and scroll down to 5200 on parameters and it is currently at 00100010. Do all these need to be changed to one or just one bit? or am I competly wrong?
The g code for the tapping cycle that has been used before.
T0404
(THRD W/DIE)
G0 X0 Z.125
G1 G97 G99 M13
M29 S500
G84 Z-1.4 R.025 F0.05906 P1
G0 X8.0 Z6.0 M9
M1
I go to system and scroll down to 5200 on parameters and it is currently at 00100010. Do all these need to be changed to one or just one bit? or am I competly wrong?
The g code for the tapping cycle that has been used before.
T0404
(THRD W/DIE)
G0 X0 Z.125
G1 G97 G99 M13
M29 S500
G84 Z-1.4 R.025 F0.05906 P1
G0 X8.0 Z6.0 M9
M1
