What's new
What's new

jet jmd-18 mill drill vise

Status
Not open for further replies.

wkola

Plastic
Joined
Feb 16, 2010
Location
clarkesville ga.
hi
I am looking to buy a vise for the mill drill that i bought. the table is 9,5 x 32 and the t slots are 5/8. the vises i was looking at are 6 inch because the mounting hole is 1/2 inch and the 5 inch vise mountng hole is 3/8. does anyone know if the 6 inch vise would be very usable for this mill drill or is it to big
thanks for any help
Pat
 
delete your post, start over w/ the dimensions of the table
and vise you need. omit the "J" word an the M+D references.
i suggest this because moderators here dislike it. and your
post will likely be locked or deleted.

read the sticky guidelines, esp #6
 
Status
Not open for further replies.








 
Back
Top