dieselfuelonly
Plastic
- Joined
- Jun 28, 2020
Not having much luck finding a flywheel coupling for this little Yanmar diesel I have. It's an Ingersoll-branded Yanmar engine, TK270M, out of a TriPac unit off a big truck. It was originally set up driving a belt pulley installed on the "B" holes of my poorly drawn diagram. I would like to turn a keyed shaft off this unit. Searching through what Hayes, Guardian, etc., have to offer I'm not seeing much along the lines of what I need. Was hoping to avoid having something custom machined to keep costs down on this little project. Any ideas of A - what standard the bolt holes on this flywheel conform to (if any?) and B - any ideas on a suitable coupling? The engine should be putting out <10HP at 1800 RPM and will be used to drive a generator head. Thanks for any help!