Grigg
Hot Rolled
- Joined
- Jun 25, 2007
- Location
- Lexington, VA
What are current options for quality new NMTB 30 end mill holders, collet chucks, and other NMTB 30 taper tooling?
If MariTool offered NMTB 30 I'd start and stop there... but no luck.
NMTB Tool Holders - MariTool
How do these others rate?
NMTB 30 Archives - Briney Tooling Systems
Tool Holders, Mill Holders, Collets: Collis Toolholder Iowa
lyndex-nikken NMTB30 holder
I'm not familiar with Briney at all, Collis and Lyndex I thought were good quality a few decades ago.
Trying to outfit a new addition to the shop. Haven't purchased or used new tool holders in years so not familiar with what's good and what to avoid these days.
And/or, should I find or make a metric drawbar and use BT30 tooling?
I don't have any 30 taper tooling at all and I'd like to stick with one version or the other and not switch drawbars all the time.
Thanks for the input,
Grigg
If MariTool offered NMTB 30 I'd start and stop there... but no luck.
NMTB Tool Holders - MariTool
How do these others rate?
NMTB 30 Archives - Briney Tooling Systems
Tool Holders, Mill Holders, Collets: Collis Toolholder Iowa
lyndex-nikken NMTB30 holder
I'm not familiar with Briney at all, Collis and Lyndex I thought were good quality a few decades ago.
Trying to outfit a new addition to the shop. Haven't purchased or used new tool holders in years so not familiar with what's good and what to avoid these days.
And/or, should I find or make a metric drawbar and use BT30 tooling?
I don't have any 30 taper tooling at all and I'd like to stick with one version or the other and not switch drawbars all the time.
Thanks for the input,
Grigg