Hi,
Can anyone please help me out how to measure the countersink with following dimensions dia 10.01mm with 0.50mm tolerance and angle 100 degrees with 40 degrees tolerance as shown in the pic
Cut a couple templates for minimum and maximum angle. The template has to be thin enough for the operator to see the fit on the angle. For a shot run even cardboard could work. Use go and not go pin gauges for the hole.
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.