NewGunPlumber
Aluminum
- Joined
- Dec 18, 2019
Recently purchased a mill that has had very little use but has been storage for approximately 15yrs. It has obviously had some form of preservative but there is some light rust on the table and other surfaces that I'd like to remove.
What is the best method to remove light rust like this without damaging the surfaces? I have seen some used machines for sale that have been wire buffed but am unsure if this would cause any damage
What is the best method to remove light rust like this without damaging the surfaces? I have seen some used machines for sale that have been wire buffed but am unsure if this would cause any damage