jrmach
Titanium
- Joined
- Jun 9, 2012
- Location
- Boise,Idaho USA
So,ordered material months ago,,now customer is in big ass hurry to machine it.Talking about 316 SS-1 1/8" OD with 20 splines.Ordered it from Grob.This is to be used as the Transom Shaft for a boat.Basically I need to machine 6 places about 2 inches long down to 1 inch diameter,,,right below the root of the spine.The bar is 6 foot long and has about a 1/8 inch bow to it.Never occurred to me to check it when material came in months ago,as got straight shit before,,,I ASSumed !
Like I said,,big ass hurry
These machined spots need/should be all in the same plane
SO
I have no big press,etc.,etc.
Is flame straightening a viable option ?
Or best just to do the best I can with what I got ?
Oh yeah,big ass hurry,,like one way or another got to be done by daylight tomorrow,ughhhhhh....
Thanks in advanced,,,
Like I said,,big ass hurry
These machined spots need/should be all in the same plane
SO
I have no big press,etc.,etc.
Is flame straightening a viable option ?
Or best just to do the best I can with what I got ?
Oh yeah,big ass hurry,,like one way or another got to be done by daylight tomorrow,ughhhhhh....
Thanks in advanced,,,