RC99
Diamond
- Joined
- Mar 26, 2005
Is there anywhere where there is a big list of available tie rod end sizes with dimensions.
I have been given the task of repairing a steering ram off a prehistoric Hough loader. The owner backed into a tree, turning the ram into a banana and then someone (no it was not me) smashed one of the tie rods with a hammer trying to flog out the tapered bit. The ram of course is a fully welded unit, that is the ends of the ram are both welded to the cylinder.
I have not yet found a tie rod end of the required dimensions. It is a male one with 7/8 18 RH thread.
I have been given the task of repairing a steering ram off a prehistoric Hough loader. The owner backed into a tree, turning the ram into a banana and then someone (no it was not me) smashed one of the tie rods with a hammer trying to flog out the tapered bit. The ram of course is a fully welded unit, that is the ends of the ram are both welded to the cylinder.
I have not yet found a tie rod end of the required dimensions. It is a male one with 7/8 18 RH thread.