ruger #1
Close
Login to Your Account
Results 1 to 3 of 3

Thread: ruger #1

  1. #1
    Join Date
    Mar 2019
    Country
    UNITED STATES
    State/Province
    Missouri
    Posts
    1
    Post Thanks / Like
    Likes (Given)
    0
    Likes (Received)
    0

    Default ruger #1

    hey guys im new to this site and I was just wondering if anyone has blueprinted a ruger #1 action and what were the steps you took

  2. #2
    Join Date
    Dec 2017
    Country
    UNITED STATES
    State/Province
    Idaho
    Posts
    325
    Post Thanks / Like
    Likes (Given)
    90
    Likes (Received)
    59

    Default

    Took one apart after a 270 round was put in it .... sadly, it was a 7mag. Needed some repairs, but never thought about truing it up. Threaded and added a brake. Nice to shoot.
    Great question and hope someone with experience will reply.

  3. #3
    Join Date
    Nov 2004
    Location
    RC, CA
    Posts
    1,949
    Post Thanks / Like
    Likes (Given)
    211
    Likes (Received)
    366

    Default

    I found one side happened to be true to the block mortise. And the front face was dead on too. 3 deg I think. Using those as references, I thread milled to correct the 3/4 deg down angle on the thread. Took it all the way out to 1-1/16 to clean up.

    I have a picture somewhere of a mandrel threaded into the original thread. Clear by eyeball it was way crooked.

    The hanger was cut off prior, and replaced with barrel mounted lugs.

    I missed on my guess of where centerline was in relation to the lever pin by a little. So the primers are hit a little off center.

  4. Likes Mram10 liked this post

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •