Good morning,
Running a probing cycle to pick up a bore for 2nd op machining but getting an alarm on the G65P810 retract line.. I have worked around this a couple of times in the past by changing the G65 P9810 to G01 but would like to figure out why I am getting this alarm. Any ideas why?
Posted code:
G00 G90 G54 X1.540 Y-1.250
G43 Z1.0 H31
G65 P8932
G65 P9810 Z-0.25 F150.
G65 P9814 D1.65 S2
G65 P9810 Z.5 F150. *Alarms out on this line, 1086 (PATH OBSTRUCTED)
G65 P9833
G0G53Z0
Thanks in advance!
Running a probing cycle to pick up a bore for 2nd op machining but getting an alarm on the G65P810 retract line.. I have worked around this a couple of times in the past by changing the G65 P9810 to G01 but would like to figure out why I am getting this alarm. Any ideas why?
Posted code:
G00 G90 G54 X1.540 Y-1.250
G43 Z1.0 H31
G65 P8932
G65 P9810 Z-0.25 F150.
G65 P9814 D1.65 S2
G65 P9810 Z.5 F150. *Alarms out on this line, 1086 (PATH OBSTRUCTED)
G65 P9833
G0G53Z0
Thanks in advance!