countryguy
Hot Rolled
- Joined
- Jul 29, 2014
- Location
- Mich, USA
Issue: Bad squeal and chatter on backside of different parts and different sizes. Always on X travel, back side, traveling to left, (X-)
10sec vid: https://youtu.be/Rqt0-BDrHa0
Detail:
The Son is on his first big PO! (whoot!!!) A36 and 1020 steel. Imco cutter, 1/2 OD, I think they call it a 525 enduro. He worked w/ Imco on selection and S&F. He's done everyting related to S&F trial and error. This is 4 different parts with different geometries. Always terrible on that move (in video)
He's going to relevel the table as an idea.. possible vibration? We wonder about the Screw and a possible worn spot? Would folks have some thoughts on this issue or if you have seen it before.
TIA
CG & Son.
10sec vid: https://youtu.be/Rqt0-BDrHa0
Detail:
The Son is on his first big PO! (whoot!!!) A36 and 1020 steel. Imco cutter, 1/2 OD, I think they call it a 525 enduro. He worked w/ Imco on selection and S&F. He's done everyting related to S&F trial and error. This is 4 different parts with different geometries. Always terrible on that move (in video)
He's going to relevel the table as an idea.. possible vibration? We wonder about the Screw and a possible worn spot? Would folks have some thoughts on this issue or if you have seen it before.
TIA
CG & Son.