I have a new vf9, trying to bore some smaller holes to size (.625) using a 3/8 endmill. With default smoothness at medium, lets say I try to open it up .001 total at 45 ipm .1 ramp, it won't cut anything off the wall but if I drop the feed rate to 35 ipm it will start pulling a bunch off the wall.
In the past on a older vf9 we could bore holes at that default smoothness and feed rate and not have a problem aslong as we were under roughly 60 ipm.
Did they change this controller that much? The safety features on the new machines are horrible. We have a 2017 mill and it's useable, but on this new one you can't even turn the spindle on at all with the door open. So if you are using a wiggler you are SOL unless you override the door locks.
In the past on a older vf9 we could bore holes at that default smoothness and feed rate and not have a problem aslong as we were under roughly 60 ipm.
Did they change this controller that much? The safety features on the new machines are horrible. We have a 2017 mill and it's useable, but on this new one you can't even turn the spindle on at all with the door open. So if you are using a wiggler you are SOL unless you override the door locks.