RockyTopMC
Plastic
- Joined
- Oct 4, 2018
Recently I have had an issue with my control freezing and running slow. I think I might have narrowed the issue down to the keypad but I wanted to run it past yall before I spent $375 on a keypad. When I start the machine up it goes straight into hang jog instead of messages and will say no Z zero. If you mess with the keyboard for a little while it will eventually act right for a minute and may or may not freeze again. It also doesn't go to the hand jog screen every time you fire it up. Normally it goes straight to the messages screen and awaits for you to push the power up button. So I got to messing with it today and I got it homed out and it would act right and then would start running slow and if you tried to go back to let say list prog or edit it would flip back to the hand jog screen and either go really slow or freeze. Like youll push a button and 2 seconds later it would beep, sometimes twice. Haas was helpful but Ive been hearing the support on the older stuff hasn't been great lately. Is it a heavy possibility its the keypad? Could it be a bad board? I couldn't find much doing a search on this particular issue and nobody seems to have it resolved.