2ferrous
Plastic
- Joined
- Oct 11, 2010
- Location
- Ontario, Canada
I'm quoting on some new work and one of the operations is deep hole drilling.
It's a 1.375" and a 1.5" hole, both 15" deep.
I can't fit it into my VF2 so I was looking at buying a HAAS HMC of some sort to do the job.
Perhaps an EC-400 or HS-1...
Second OP is to face the end and put in a snap ring groove.
That will be the easy, but once again I think I'll need an HMC to do the job.
Material is a rectangular block of aluminum around 17" long so a turning center is out.
Any input would be appreciated.
Thanks, Timothy
It's a 1.375" and a 1.5" hole, both 15" deep.
I can't fit it into my VF2 so I was looking at buying a HAAS HMC of some sort to do the job.
Perhaps an EC-400 or HS-1...
Second OP is to face the end and put in a snap ring groove.
That will be the easy, but once again I think I'll need an HMC to do the job.
Material is a rectangular block of aluminum around 17" long so a turning center is out.
Any input would be appreciated.
Thanks, Timothy