bishbash25
Plastic
- Joined
- May 13, 2019
Just recently started using the haas control manually to program fanuc programs.
Also uk based.
I have a drilling question regarding G83
After you move say to first position i. e
X10. Y10. It commands to drill at this position say 5mm deep
If the next hole was 10mm deep can i use this line
X20. Y10.,Z-10
Without cancelling with G80 and re writing G83 with Z-10
Thanks
J
Sent from my SM-G950F using Tapatalk
Also uk based.
I have a drilling question regarding G83
After you move say to first position i. e
X10. Y10. It commands to drill at this position say 5mm deep
If the next hole was 10mm deep can i use this line
X20. Y10.,Z-10
Without cancelling with G80 and re writing G83 with Z-10
Thanks
J
Sent from my SM-G950F using Tapatalk