hend.engineering
Aluminum
- Joined
- Jul 30, 2019
Hi,
Successfully drip feeding programs to my VF but encounter a problem mid program where the control gives a "incorrect code" error.
Turns out this is actually the buffer that's full and the machine isn't crunching the code as fast as it's receiving and it happily runs the program if I break it down into individual operations and the same line it previously stopped on works fine - Problem solved!
As a solution to run a program continuously, Should I drip feed at a lower baud rate? Or am I missing a setting where the control could be pausing the program until there's space?
Using "NC link" program to drip the code, and all the standard settings 9600, Even, Xon Xoff, 7bits.
At the moment, unless I'm missing an obvious button push I can only start the program dripping from NC link and not from the control. Am i missing something?
Thanks in advance,
Tom.
Successfully drip feeding programs to my VF but encounter a problem mid program where the control gives a "incorrect code" error.
Turns out this is actually the buffer that's full and the machine isn't crunching the code as fast as it's receiving and it happily runs the program if I break it down into individual operations and the same line it previously stopped on works fine - Problem solved!
As a solution to run a program continuously, Should I drip feed at a lower baud rate? Or am I missing a setting where the control could be pausing the program until there's space?
Using "NC link" program to drip the code, and all the standard settings 9600, Even, Xon Xoff, 7bits.
At the moment, unless I'm missing an obvious button push I can only start the program dripping from NC link and not from the control. Am i missing something?
Thanks in advance,
Tom.