My Haas barfeeder on a ST-20 has a tendency to malfunction when it loads a new bar.
Exactly what happens is the material travels 2 or 3 feet past the point where it is supposed to stop
No way will I put in a M99 when I see that
I have setting #3100,#3101 and #3102 set.
However on small diameter material (1/4-1/2) it seems to work OK.
Any idea I should should look into
Exactly what happens is the material travels 2 or 3 feet past the point where it is supposed to stop
No way will I put in a M99 when I see that
I have setting #3100,#3101 and #3102 set.
However on small diameter material (1/4-1/2) it seems to work OK.
Any idea I should should look into