Hi guys,
We have recently purchased a new Mini Mill 2, which has been delivered to our premises (EU) which has single phase 240V power. We ordered this machine on condition that it works with both, single and 3-phase power (or so we thought?).
During commissioning, technician could not start the machine, claiming that MM2 comes in two variants; 1ph and 3ph. Since then we are going back and forth on this issue with HAAS for a few weeks now.
The latest information is that our machine which is the "high voltage" 400V model (probably) does not do single phase. But the information is not definite yet.
I included some photos of the machine panel and a link to the electrical installation guide.
If you guys have some experience with a similar situation, please chip in.
Thanks!!!
Dimos
We have recently purchased a new Mini Mill 2, which has been delivered to our premises (EU) which has single phase 240V power. We ordered this machine on condition that it works with both, single and 3-phase power (or so we thought?).
During commissioning, technician could not start the machine, claiming that MM2 comes in two variants; 1ph and 3ph. Since then we are going back and forth on this issue with HAAS for a few weeks now.
The latest information is that our machine which is the "high voltage" 400V model (probably) does not do single phase. But the information is not definite yet.
I included some photos of the machine panel and a link to the electrical installation guide.
If you guys have some experience with a similar situation, please chip in.
Thanks!!!
Dimos