chevelless502
Plastic
- Joined
- Aug 18, 2017
We have a 2004 Haas SL30T lathe. Recently the probe on the tool setter broke the touch probe. we have that fixed. Now when we go to use it for setting the depth of a drill bit on the live tool (X axis), it doesn't seem to set the depth correctly. We went in and recalibrated the probe and still have the same issue. We also have tried to just set the X axis off of the side of the stock in the chuck and it doesn't seem like it is registering that correctly. The only way we have been able to get up and running is to set the drill bit (in the live tool) off the side of the part then double the diameter of the part it was set off of. We then go into the program and tell it to drill the cross holes nearly 1.00" deeper than we had to before. Any ideas or suggestions?