RMS Machine
Aluminum
- Joined
- Nov 16, 2006
- Location
- NE Nebraska
Has anyone replaced the Y-axis ball screw on their TM Mill (1,2 or 3 should be about the same) This would be on a mid 2000's model before the enclosed models.
I have about 0.0018-.0020 play in the Y-Axis and it is affecting my surface finish during certain operations.
Any tips or tricks to this work, anything I should watch out for? I was planning to take it out and send it to a rebuild company.
Any good recommendations on ball screw rebuilders?
I have about 0.0018-.0020 play in the Y-Axis and it is affecting my surface finish during certain operations.
Any tips or tricks to this work, anything I should watch out for? I was planning to take it out and send it to a rebuild company.
Any good recommendations on ball screw rebuilders?