Question with details below: Does anyone have any recommendations on a phase converter that runs off a 100amp box that is able to run a 56A 3 phase load (VF-2 CNC and future vibratory bowl tumbler)
Been looking around the forums for the past few days to see what others are using to power their VF-2 units. The one thing I found is that everyone has a different power/phase converter setup which makes sense based on power in and what you are trying to run.
We have a 100 amp service and currently have a 10,000 rpm VF-2 and in the future a vibratory bowl tumbler.
Haas VF-2 CNC - 30HP 3-Phase, 50A 240V
Royson 6 CTV IS Tumbler - 2.5 HP 3-Phase, 6.4A 240V
I spoke with the good folks over at American Rotary with my 56.4A requirement and they have an AD-40 which meets the amp requirement but it requires 125amp, 25amp over what I have available. The highest HP they can provide on 100amp service is 15HP or 42A load with their AD-30 unit.
I am looking for a cost-effective solution to run these two machines off a 100 amp service, have any recommendations?
Thanks for the help!
Cheers,
Brian
Been looking around the forums for the past few days to see what others are using to power their VF-2 units. The one thing I found is that everyone has a different power/phase converter setup which makes sense based on power in and what you are trying to run.
We have a 100 amp service and currently have a 10,000 rpm VF-2 and in the future a vibratory bowl tumbler.
Haas VF-2 CNC - 30HP 3-Phase, 50A 240V
Royson 6 CTV IS Tumbler - 2.5 HP 3-Phase, 6.4A 240V
I spoke with the good folks over at American Rotary with my 56.4A requirement and they have an AD-40 which meets the amp requirement but it requires 125amp, 25amp over what I have available. The highest HP they can provide on 100amp service is 15HP or 42A load with their AD-30 unit.
I am looking for a cost-effective solution to run these two machines off a 100 amp service, have any recommendations?
Thanks for the help!
Cheers,
Brian