HeWhoBuilds
Plastic
- Joined
- Feb 12, 2020
I have a Haas VF3 with a rotary table installed. My G54 offset for Z is 19.7885 and when I drill or mill anything on top, the depth and location comes out perfect. The problem i'm having is that when I use the rotary table. If I tilt the part 90 degrees let say, and I drill a hole 1" from the top of the part the Y axis isn't moving too far back. The hole comes out being 0.983 from the top of the part and about 0.017 too deep. I'm programming everything in mastercam 2018. How do I fix this issue?