Shawn_Laughlin
Aluminum
- Joined
- Mar 28, 2019
If I stick a tool in the spindle and mount an indicator on the table and touch off on the actual cutting tool and grab the holder right below the gauge flange and pull and push should I see any movement? Ima pretty strong 248 lb man but wouldn’t think I could make this thing move as much as I did, about .0080,give or take .0005.
It’s the only thing I can think of that’s causing my inconsistent finish issues. I can make a cut and have steps and make the identical cut again and some step overs won’t have a noticeable step at all and then there’s times along a cut length where there’s patches that have no step and then a step and then no step. Wish I had a better camera to take a picture.
It’s the only thing I can think of that’s causing my inconsistent finish issues. I can make a cut and have steps and make the identical cut again and some step overs won’t have a noticeable step at all and then there’s times along a cut length where there’s patches that have no step and then a step and then no step. Wish I had a better camera to take a picture.