What's new
What's new

How do I get M0 signal from Haas NGC during Machine Monitoring?

Digitechpune

Plastic
Joined
Jan 18, 2021
I am a system Integrator of CIMCO-MDC.
My customer has a Haas Machine without RS-232.
The machine has LAN Port.
I have used CIMCO-MDC software to monitor the machine's status.
It works fine.

But, when the operator puts the machine in halt condition, by M0 in Auto mode, I
am not able to get that state from the Ethernet port.
The MDC system still shows me IN CYCLE status.

Is there a way out to get this state?
- Deepak Bodhani
 
Definitely probably best to make that call... maybe consider: Go 'man in the middle' with Wireshark or Fiddler Everywhere on a PC and monitor the ethernet traffic? It might actually be there? Just a thought... CG.


I am a system Integrator of CIMCO-MDC.
My customer has a Haas Machine without RS-232.
The machine has LAN Port.

I have used CIMCO-MDC software to monitor the machine's status.
It works fine.

But, when the operator puts the machine in halt condition, by M0 in Auto mode, I
am not able to get that state from the Ethernet port.
The MDC system still shows me IN CYCLE status.

Is there a way out to get this state?
- Deepak Bodhani
 
i'm sure there's a MTConnect variable or three which you could poll to determine the status. which one is the right one is another question altogether.

a few guesses:
RunningFlag
OptionStop
GREEN_BEACON

you'll probably have to figure out which combination is appropriate for the specific state.
 








 
Back
Top