What's new
What's new

Invert Skip on NGC

CutEdge

Aluminum
Joined
May 22, 2015
Simple question: how does one set the Invert Skip parameter on the Next Generation Control, on a Haas TM-1 machine?

On my old machine (Classic Control), I would set parameter 57, bit 23.

I am using 3rd party probes, not Renishaw. It has been working fine for years.
 
You could find a logic inverter instead, otherwise I don't think the next gen allows you to hurt yourself.
 
I discovered that there is also a parameter 734:29 on the classic control. Still, no help on the new control.

It would have been much simpler to change a byte of data than to buy a whole new relay, normally closed instead of normally open. But it seems that this is the only way to do it now.
 








 
Back
Top