The code below works fine on my VF-2
Stops at M21 and waits for a M-Fin signal but on a friends TL-1 it just runs until the end of the program not stopping.
Any ideas?
I'm not sure if there is some option that needs to be turned on but I don't think so.
Thanks.
Stops at M21 and waits for a M-Fin signal but on a friends TL-1 it just runs until the end of the program not stopping.
Any ideas?
Code:
S200;
M03;
M21;
M03;
S1000;
I'm not sure if there is some option that needs to be turned on but I don't think so.
Thanks.