BruceWayne
Plastic
- Joined
- Aug 31, 2013
- Location
- NYC
Hello All,
For HAAS ST-10.
How can we prevent an operator from changing parts at the WRONG time. LOL
We have a M00 mid prg for chip clearing. However, you can when not paying attention open the chuck, remove the half completed part and install a new blank. AND then we have a nice crash.
I would think there should be a setting or M code which prevents the chuck from opening if your are "in prg". Same as it prevents the chuck from opening if it is turning.
A M00 is still "in prg". So I am hoping this is an easy one.
And yes, we had an operator find this out the hard way and ruin our bore bar.
Thanks,
For HAAS ST-10.
How can we prevent an operator from changing parts at the WRONG time. LOL
We have a M00 mid prg for chip clearing. However, you can when not paying attention open the chuck, remove the half completed part and install a new blank. AND then we have a nice crash.
I would think there should be a setting or M code which prevents the chuck from opening if your are "in prg". Same as it prevents the chuck from opening if it is turning.
A M00 is still "in prg". So I am hoping this is an easy one.
And yes, we had an operator find this out the hard way and ruin our bore bar.
Thanks,