What's new
What's new

New 2020 Haas VF2 SS debug or manual tool changer recovery mode

allenp

Aluminum
Joined
Jul 13, 2015
Hello, is it possible to manually recover or test tool changer like on older VF2 (not SS) series machine by using "Debug" mode?
I don't see any option on the new control to do this, there is no setting #7 like there and it doesnt do anything when typing Debug in alarms?
 
Hello, is it possible to manually recover or test tool changer like on older VF2 (not SS) series machine by using "Debug" mode?
I don't see any option on the new control to do this, there is no setting #7 like there and it doesnt do anything when typing Debug in alarms?

NGC does auto recovery by default, but if it doesn't work it will walk you through step by step, homing the arm, moving the pot up/down etc. Not sure what you mean about testing though.
 








 
Back
Top