What's new
What's new

New Shop Owner, New to Haas controls. Work offset ?'s

CVMW

Plastic
Joined
Aug 31, 2021
Hello, I am a new shop owner and also new to Haas controls. I was a tool room machinist for 6 years, worked with Mazak and Hurco and am finding odd differences that I had not anticipated. After probing tools and the part I go to check that everything is correct, G54 G00 G90 X0. Y0.; G43 H01 z0.1; M30;. Tool goes to exactly where it's supposed to but the positional display show G54 (X0 Y0 Z4.4171) (Tool length offset plus .100). On my Hurco and Mazak machines it would show X0. Y0. Z.1. I have been trying to figure out what setting I need to mess with and have been unsuccessful in getting the result I am looking for. How can I change this? Any and all help and advice is appreciated. Thank You.
 
the G43 H01 gets cancelled after the program ends, so if you're hitting the M30, it goes away after that. if you single block through it, you should see the correct position before you hit the M30 and finish the program.
 








 
Back
Top