UPDATE: i got it figured out,all i can say is watch the decimal points on the degrees.
T1111 m31
M133 p500
G19 m08
G98
G28 h0
M154
C180
G00 g54 x8.5 z-5.3149
G01 x8.5 z-5.3149 f1.0. (Plunge)
G01 c720 x8.250 z-9.7637 f10.0
G00 x8.5
G01 c720 x8.250 z-9.7637 f1.0 (plunge)
G01 c180 z-5.3149 f10.0
G00 x8.5 m33
G99
G28 u0 m09
G28 w0 m135
G28 h0 m155
The problem i am having is the c axis isn’t rotating when i run this. The dro shows the degree rotation is moving.
Am i missing something?
Not sure if this will even do the oil groove.
Thank you
Frankie.
I am also trying to do this with radial live tooling.
T1111 m31
M133 p500
G19 m08
G98
G28 h0
M154
C180
G00 g54 x8.5 z-5.3149
G01 x8.5 z-5.3149 f1.0. (Plunge)
G01 c720 x8.250 z-9.7637 f10.0
G00 x8.5
G01 c720 x8.250 z-9.7637 f1.0 (plunge)
G01 c180 z-5.3149 f10.0
G00 x8.5 m33
G99
G28 u0 m09
G28 w0 m135
G28 h0 m155
The problem i am having is the c axis isn’t rotating when i run this. The dro shows the degree rotation is moving.
Am i missing something?
Not sure if this will even do the oil groove.
Thank you
Frankie.
I am also trying to do this with radial live tooling.