countryguy
Hot Rolled
- Joined
- Jul 29, 2014
- Location
- Mich, USA
I tried a post like this before... Been slow so I will try this again and ask among our 'Elder's of Haas' Short as I can...
OS 9 to 10 differences
Q: Is there any benefit of a 9.64N (final 9) VERSUS 10.34 (I think 10 final). As a operating system version on our 98 VF/4?
Coprocessor and Co-pro BIOS feature - 'what-tis' :-)
Q: Does the coprocessor and Co-Pro OS install do anything besides run the 1000 block look-ahead (as the white sheet lists this feature I think). Early HSM is what I think it's been called?
Q: Was this 1K look ahead even an option w/ 9.64? In short- is there a Co-Pro BIN file out there for 9.64?
There is just so little information on what V9 vs V10 offered to entice and what a Co-Pro really offers?
Why: Running the Haas in 9.64, no copro option, 5 axis mode (I installed the 5th setup) on a TRT-210. The simple 3+2 we do runs well enouth. But I wanted to understand if getting this thing a bump on the CoPro side would help any? Plus if we did wish to run some simple simultaneous in 5 axis.
Soo... if an upgrade from regular 9 to 10 does anything worthwhile in our config.
OS 9 to 10 differences
Q: Is there any benefit of a 9.64N (final 9) VERSUS 10.34 (I think 10 final). As a operating system version on our 98 VF/4?
Coprocessor and Co-pro BIOS feature - 'what-tis' :-)
Q: Does the coprocessor and Co-Pro OS install do anything besides run the 1000 block look-ahead (as the white sheet lists this feature I think). Early HSM is what I think it's been called?
Q: Was this 1K look ahead even an option w/ 9.64? In short- is there a Co-Pro BIN file out there for 9.64?
There is just so little information on what V9 vs V10 offered to entice and what a Co-Pro really offers?
Why: Running the Haas in 9.64, no copro option, 5 axis mode (I installed the 5th setup) on a TRT-210. The simple 3+2 we do runs well enouth. But I wanted to understand if getting this thing a bump on the CoPro side would help any? Plus if we did wish to run some simple simultaneous in 5 axis.
Soo... if an upgrade from regular 9 to 10 does anything worthwhile in our config.