Bruce Mowbray
Plastic
- Joined
- Jun 30, 2008
- Location
- Pennsylvania
Hello,
I have an older Haas VF1 with the shot pin spindle orientation. My problem is that when doing a tool change at speeds over 2500 RPM, the shot pin tries to engage before the spindle comes to a stop and the "Tommy Gun" noise happens. I watched the diagnostic page and the orientation is started before the spindle stops. What senses that the spindle is stopped, or, is there a delay time setting that needs to be set higher or lower? I know this all has to happen in sequence but something is out.
Thanks in advance
Bruce Mowbray
1993 Haas VF1
I have an older Haas VF1 with the shot pin spindle orientation. My problem is that when doing a tool change at speeds over 2500 RPM, the shot pin tries to engage before the spindle comes to a stop and the "Tommy Gun" noise happens. I watched the diagnostic page and the orientation is started before the spindle stops. What senses that the spindle is stopped, or, is there a delay time setting that needs to be set higher or lower? I know this all has to happen in sequence but something is out.
Thanks in advance
Bruce Mowbray
1993 Haas VF1