Shawn_Laughlin
Aluminum
- Joined
- Mar 28, 2019
I tried to probe the first ever tool in my mill and I got “Tool length out of range” and I can’t find anything in the manual or online of what is causing this. I set my approximate tool length to 4.625, well under the max tool length of machine. Has anyone else had this happen to them?
Also when I first powered it up after the tech finished and left, and the last operation was on the screen and the first line said “Complete probe calibration”. I’m guessing this right and it’s just the last thing he did or is it saying you need to complete the calibration?
Also, I knew I was going to lose table with the setter and the 4th but didn’t realize I was going to lose as much. The tool probe is inset enough to max out tool diameter by more than 2x around a 12 or 14” diameter tool and that’s giving it plenty of room to clear the setter when measuring diameter. That is not an exaggeration. My probe is mounted to the left side of table bc of 4th. Also the hrc210 is installed about 4” from the edge of the tables. Once you add on for the chuck and mounting plate that a lot of used up table. He said he was giving room so the rotary didn’t hit the window and I took his word for it but after he left I jogged over and there is plenty of room.
So I think I could get at least 10 more inches of tables by moving those two option further out. Is there something I’m not seeing that is keeping me from doing that?
Here’s a couple picture.
Also when I first powered it up after the tech finished and left, and the last operation was on the screen and the first line said “Complete probe calibration”. I’m guessing this right and it’s just the last thing he did or is it saying you need to complete the calibration?
Also, I knew I was going to lose table with the setter and the 4th but didn’t realize I was going to lose as much. The tool probe is inset enough to max out tool diameter by more than 2x around a 12 or 14” diameter tool and that’s giving it plenty of room to clear the setter when measuring diameter. That is not an exaggeration. My probe is mounted to the left side of table bc of 4th. Also the hrc210 is installed about 4” from the edge of the tables. Once you add on for the chuck and mounting plate that a lot of used up table. He said he was giving room so the rotary didn’t hit the window and I took his word for it but after he left I jogged over and there is plenty of room.
So I think I could get at least 10 more inches of tables by moving those two option further out. Is there something I’m not seeing that is keeping me from doing that?
Here’s a couple picture.