Hello everyone
My probe tip seems to be having a hard time staying centered. I took it apart cleaned all the oil that was between the body and the holder and put it back together hoping it solved my problems. Re centered it and used it no problems. Come back to the shop today, cleaned the spindle taper and the prober taper loaded it up and checked center and it was out a .0005" over night. Not sure what i'm doing wrong. So I adjusted it again to no run out, tightened the top set screws that hold it in and used it. checked it 3 parts later and it was out another .0004". I did notice this new probe tip is off center where it gets shoved into the little metal taper. Could the stylus be moving? Not really sure what else to do. It's slowing me down constantly checking it.
Thank you.
My probe tip seems to be having a hard time staying centered. I took it apart cleaned all the oil that was between the body and the holder and put it back together hoping it solved my problems. Re centered it and used it no problems. Come back to the shop today, cleaned the spindle taper and the prober taper loaded it up and checked center and it was out a .0005" over night. Not sure what i'm doing wrong. So I adjusted it again to no run out, tightened the top set screws that hold it in and used it. checked it 3 parts later and it was out another .0004". I did notice this new probe tip is off center where it gets shoved into the little metal taper. Could the stylus be moving? Not really sure what else to do. It's slowing me down constantly checking it.
Thank you.