I am wanting to check how to wire in the OMI-2T into the Haas 33-0615 cable for an 08VF2.
I have received help from one member and picked up a diagram posted by another. They are different in that one of them suggests wiring in both Probe status 1 and 2 from the OMI-2T into the equivalent OMI-2H's single Probes status SSR. The other suggests using only the Probe status 1, I know you have to set SW1 and SW2 to 'level' and NC on 2T, although if Probe status 2 is not used (wired in) then that is a moot point for the second SSR but important for the first.Both attached. Best resolution I have but still not easy to read. However you can see what is proposed re the SSR's.
I also notice the relay switching for the initial trigger is different on both diagrams for the OMI-2T and OMI-2H?? Both attached,
Has anyone actually run a 2T on a Haas with an OTS and 40-2 and have it work?
Any help would be much appreciated.
Thank you
I have received help from one member and picked up a diagram posted by another. They are different in that one of them suggests wiring in both Probe status 1 and 2 from the OMI-2T into the equivalent OMI-2H's single Probes status SSR. The other suggests using only the Probe status 1, I know you have to set SW1 and SW2 to 'level' and NC on 2T, although if Probe status 2 is not used (wired in) then that is a moot point for the second SSR but important for the first.Both attached. Best resolution I have but still not easy to read. However you can see what is proposed re the SSR's.
I also notice the relay switching for the initial trigger is different on both diagrams for the OMI-2T and OMI-2H?? Both attached,
Has anyone actually run a 2T on a Haas with an OTS and 40-2 and have it work?
Any help would be much appreciated.
Thank you