ukkie
Plastic
- Joined
- May 29, 2020
Hi guys,
I have a VF4 SS with WIPS and I'm struggling to get the OTS to repeat. Does anyone have any suggestions? I had Haas out not that long ago to check something and they calibrated the system then ( about 4 weeks ago).
Today I tested a perfectly ground 10mm endmill ( brand new tool) in a shrink fit holder and touched the tool off. I repeated this about 7-8 times without changing anything in the offsets and I got a 40 micron swing in the readings. Started off at 9.999 then went to .994, then .988 then 10.028 and so on.
I know it could well be that the calibration is out for some reason but the machine has done next to nothing since it was calibrated and its a brand new machine. Could it be anything else causing this issue?
Thanks in advance!
I have a VF4 SS with WIPS and I'm struggling to get the OTS to repeat. Does anyone have any suggestions? I had Haas out not that long ago to check something and they calibrated the system then ( about 4 weeks ago).
Today I tested a perfectly ground 10mm endmill ( brand new tool) in a shrink fit holder and touched the tool off. I repeated this about 7-8 times without changing anything in the offsets and I got a 40 micron swing in the readings. Started off at 9.999 then went to .994, then .988 then 10.028 and so on.
I know it could well be that the calibration is out for some reason but the machine has done next to nothing since it was calibrated and its a brand new machine. Could it be anything else causing this issue?
Thanks in advance!