Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Sl30 using tailstock to drill?
- Thread starter FrankieB
- Start date
- Replies 6
- Views 2,046
Job Shopper TN
Cast Iron
- Joined
- May 17, 2015
- Location
- Southeast TN
Tailstocks on a Haas unfortunately only have two speeds, rapid and feed, not controllable via an F code, plus they can only be positioned in .100" increments. They're really intended to be used for centers only, unfortunately.
Mike1974
Diamond
- Joined
- Nov 5, 2014
- Location
- Tampa area
There is a work-a-round.. drill at .100 rev! LOL (that's a joke BTW)
Seriously, just need to figure out a way to "squeeze" in one more tool- rough and finish with same od tool, drill and bore with insert drill..... I dunno...
