Shawn_Laughlin
Aluminum
- Joined
- Mar 28, 2019
Does haas break in the spindle at the factory or do I have to do it?
The tech is coming back tomorrow to mount the rotary and to set up the probe and I asked him today before leaving what was left and he said you could actually make a cut “I’m not going to until he’s finished” but I was still wondering if a break in needed to be performed other than warm up.
So what say y’all?
The tech is coming back tomorrow to mount the rotary and to set up the probe and I asked him today before leaving what was left and he said you could actually make a cut “I’m not going to until he’s finished” but I was still wondering if a break in needed to be performed other than warm up.
So what say y’all?