athack
Stainless
- Joined
- Nov 2, 2009
- Location
- Michigan USA
I know this is very broad/vague but I am just looking for advise on what people have run into before. We have slippage on certain materials when the thrust is not that great. Some bigger parts that require more thrust don't slip but these are. It is .960 diameter Dura Bar that is being hollow milled.
Oil level is good, chuck is lubed. The holding method is Warner Swasey Collet pads fir to a 3 jaw. Pressure readings are good. Before I take chuck off and clean everything I just wanted some input as to what other people have found when things start slipping.
Thank you for the help.
Oil level is good, chuck is lubed. The holding method is Warner Swasey Collet pads fir to a 3 jaw. Pressure readings are good. Before I take chuck off and clean everything I just wanted some input as to what other people have found when things start slipping.
Thank you for the help.