Hi all. Been lurking a while, first post. I'm upgrading from a smaller manual mill and am looking at a 2010 SMM2 with an apparently somewhat rare side-mount tool changer. The entry to my shop is 95" without cutting into door frames, etc. I'm wondering if anyone on here with a similar machine could confirm the lowest (i.e. shippable) height of this model machine. I've looked at the documentation on the Haas website but that's all for the SMM2 with umbrella tool changer. Looking at pics of the umbrella vs SMTC it looks like the SMTC definitely adds some height, but I'm not sure how much. If the machine ship height is higher than 95" the next question would be - are there components that can be removed (relatively easily) and then re-installed after it's in the shop? I've pinged Haas directly about the ship height but haven't gotten a response yet. I'm looking at a machine in another state and have asked the seller to confirm the height, but I thought I'd ping this group to see if I could get any confirmation and/or experiences people have had (i.e. if you had to remove anything and, if so, if that was a big deal or relatively doable) with getting this machine into their shop. Thanks for any input.