prime_mover
Aluminum
- Joined
- Jul 3, 2017
Seems there is always a little tooling mark on the corners of parts I machine on Haas mills. I usually round corners with a .010" radius. It's only a couple lines of code around the radius, an IJK move. I do a finishing pass after roughing. I am using mastercam. I do not have the Haas HSM control option enabled.
One way to eliminate this is to cut the parts with a square toolpath, then round the corners after, using slightly truncated corner radius geometry so that there is an angled lead into the cut. It would be more efficient not to have to do this however.
Does anyone have other solutions?
One way to eliminate this is to cut the parts with a square toolpath, then round the corners after, using slightly truncated corner radius geometry so that there is an angled lead into the cut. It would be more efficient not to have to do this however.
Does anyone have other solutions?